/ REGISTER HERE shopping cart 0 Item(s)
sculpture supply
sculpture supply canada about us contact us ordering events news techinical info videos media
SEARCH
SEALERS & RELEASES
» Acrylic Stone Sealer
» Aquacon Concrete Release
» Baby Powder
» Bee's Oil Wax
» Clear Guard Lacquer
» ColorLoc Lacquer
» Ease Release 200
» Ease Release 205
» Ease Release 2831
» Ease Release 300
» Ease Release 400
» In & Out Concrete Release
» Krylon Clear Gloss Sealer
» Krylon Clear Matte Sealer
» Krylon Triple Thick Glaze
» One Step Sealer Release
» Peacock Flattening Wax
» Permalac EF Sealer
» Permalac Sealer
» Permalac Sealer 2K
» Permalac Thinners
» Proseal Stone Sealer
» Sculpt Nouveau Patina Wax
» Sculpt Nouveau Thinners
» Sonite Wax
» SuperSeal
» U12 Mold Rinse
» Universal Mold Release
» Vaseline
» Zinsser Bulls Eye Primer
» Zinsser Bulls Eye Shellac
Home : Sealers & Releases : In & Out Concrete Release
 

Min Qty * Price
1 $73.50
4 $69.00

Qty
*All prices are in Canadian funds.

pdf

In & Out II Concrete Release Gallon (799287)
IN & OUT II water soluble release agent will aid in releasing concrete or gypsum plaster castings from Smooth-On rubber molds. Provides a clean, positive release and does not interfere with or affect surface detail and helps minimize air bubbles in finished castings. Sold in One Gallon pail.

Simplify Your Production Casting With IN & OUT II
Will Not Stain / Soften Concrete Or Gypsum Surfaces
Mix With Water - Economical
Will Not Affect Color Pigmenting Of Cast Concrete
Minimizes "Bug Holes" In Concrete And Air Bubbles In Gypsum Castings
Keeps Molds Clean - Does Not Build Up
Significantly Extends Mold Life

Directions Store at room temperature (72 °F / 23 C°). Do not use below 50° F / 10°. This product has a limited shelf life and should be used as soon as possible. Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk.

Application Apply IN & OUT II thoroughly with brush, roller or spray. If pressure spraying, pressure should be 25 psi (172 kPa) or higher. For uniform spray applications of release agent, flat spray tips are suggested. Do not allow release agent to puddle. Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if perfor-mance of this material is in question. Do Not Over Apply. Applying too much release agent will cause air bubbles "wormtracks", "bugholes" or pitting on surfaces.

Mix 4 parts water to 1 part In & Out II. Mixing can be done by hand or slow speed mixer. Do not shake or agitate as this may cause product to foam. How you dilute IN & OUT II (amount mixed with water, coverage and frequency of application) will depend on the concrete aggregate mix and the form material you are casting into. For example, when casting concrete with a low grit/high sand content (minimal abrasion) into a polyurethane mold, the mix ratio of water to IN & OUT II can be 4 : 1. High grit content may call for a
dilution ratio of 2 parts water to 1 part release agent. Mix only amount needed for one day. Mixture may separate after 24 hours. Re-mix to a uniform consistency and apply.