Pro Model 4-in-1 Hot Wire Foam Kit (226905)
This kit includes all four basic tools: the Sculpting Tool w/tensioner, Engraving Tool, Freehand Router, and 3" Hot Knife. Plug into the Multi-Heat Pro Power Station and start cutting! The Multi-Heat Pro Power Station has four heat settings which allows you to set the optimal cutting speed for all of our Craft and Pro Tools for more creative sculpting. This power supply has special overload protection and operates at 100-240 volts. Comes with the Multi-Heat Pro Power Station, 6 hot-wires for the Sculpting Tool which are heavier than the wires used with the Crafters powered model, 5 blades with the Freehand Router, and the 85 minute Foam Factory Instructional DVD. Everything is packaged in a sturdy toolbox for all the pro tools and accessories.
Sculpting Tool is designed for freehand sculpting, carving, and scroll cutting in foam. Tool arms can be adjusted by moving closer together or fully spread to 8" opening. Now comes with a handy slide switch right on the handle.
Engraving Tool is perfect for engraving bricks, blocks, stones, words, and other shapes for detailed looking walls, abutments, portals, slats, cobblestone roads, signs
and more. A fine finishing tool for detailing any type of 2-D or 3-D sculpture or model. Only the tip heats up.
The Hot Knife is a combo hand held scroll saw and power drill that cuts foam with fast clean surgical precision. The 6 inch blade is made from thin tough steel, with a unique round shape that slices quickly and cleanly in any direction like magic.
Freehand Router Configure the Blade Into Any Shape! Comes with 5 ultra-stiff, yet shapeable 10.5" wires that bolt onto the arms. Scoop out big or tiny pieces of foam for any level of control. The Freehand Router is to foam what the chisel was to stone. Can only be used with the Pro Power
Multi-Heat PRO Power Station has four heat settings which allows you to set the optimal cutting speed for all of our Craft and Pro Tools for more creative sculpting. This power supply has special overload protection and operates at 100-240 volts.
Hot Wire Foam Factory Instructional DVD contains 17 chapters totalling 90 minutes of instruction featuring all the basics you need to get started immediately and make just about any shape imaginable out of polystyrene foam. From precise architectural shapes, to freeform miniatures, to huge shapes. The best techniques for painting and gluing, plus tons of handy tips.